Each of the six springs and hinges which correlate with internal link deformation may actually be several coincident components which form a system of springs and dashpots. Either translation or rotation may induce shear deformation. As such, dj2 represents the location for 1-2 plane shearing and 1-3 plane bending, while dj3 is the reverse. Shear-spring location may be specified in terms of distance from joint j, where dj2 is the major-axis shear-spring location, and dj3, the minor-axis. Viscoelastic damping is specified in Force/Velocity unitsĪll shear deformation is assumed to occur within a shear spring.Isolation devices (biaxial-plasticity and friction-pendulum isolators with optional uplift).Gap (compression-only) and hook (tension-only) elements.Kinematic, Takeda, and pivot hysteretic behavior (multi-linear uniaxial plasticity).Multi-linear springs (uniaxial elasticity).Link force-deformation (F-D) relationships may be specified for each of the 6-DOF to simulate: To utilize nonlinear and frequency-dependent properties, corresponding analysis cases must be defined and run. Internal deformation is then calculated from joint j displacement relative to joint i, where i may be grounded to simulate a support point. Linear, nonlinear, and frequency-dependent properties may be assigned to each of the six deformational degrees-of-freedom (DOF) which are internal to a link, including axial, shear, torsion, and pure bending. Msiexec /i Setup.msi SHOWACTIVATE=0 NGEN=1A link object connects two joints, i and j, separated by length L, such that specialized structural behavior may be modeled. An example looks like: Setup.exe /v"SHOWACTIVATE=0 NGEN=1" Other CSI installers provide two options to control how the installation executes. For this reason, it is recommended to always specify the LicenseMode and SHOWACTIVATE parameters when installing via the command line. Both perform the same when run from the command line except for their default LicenseMode and SHOWACTIVATE parameters. This will create a LEVEL.TXT file in the installation folder containing the level name.ĮTABS v19 currently offers two installers.
#Csi bridge 2014 software
Level - sets the desired license level to use when the software is run.This will create an LMHOST.INI file in the installation folder containing the server name or IP address. Server - sets the name or IP address of a legacy network license server.Currently this only works for cloud licensing, allowing the cloud license to be activated at installation time instead of when the software is first run. ActivationKey - sets a license activation key.LicenseMode - sets the desired license mode for the software to use:.
NGEN - specifies whether to perform native-image generation:.SHOWACTIVATE - specifies whether to prompt for standalone license activation:.Setup.msi should be changed to the name of the MSI file extracted from the InstallShield setup file.Īnd the parameter values are specified as: Setup.exe should be changed to the name of the downloaded InstallShield setup file Msiexec /i Setup.msi SHOWACTIVATE=0 NGEN=1 LicenseMode=Cloud ActivationKey=8AD7BF02-176C-4182-9A39-42534B8EC410 Server=MyLicenseServer Level=Plus Setup.exe /v"SHOWACTIVATE=0 NGEN=1 LicenseMode=Cloud ActivationKey=8AD7BF02-176C-4182-9A39-42534B8EC410 Server=MyLicenseServer Level=Plus" The installers provided for CSiBridge v23, ETABS v19, and SAP2000 v23 offer parameters to control how the installation executes and to specify values related to licensing.
#Csi bridge 2014 windows
The Windows installer is very specific about these and will not perform as expected unless the syntax is exactly as expected.
NOTE: When using the command line, it is important to pay close attention to placement of double quotes ("), spaces, and other characters.